How to lay artificial turf for landscape leisure greening

Nowadays, artificial turf is widely used by us because of its convenient use and low price. Environmental beautification is closely related to our lives. In order to create a beautiful indoor and outdoor environment, artificial turf plays an important role. Today, the editor tells you how to lay the artificial turf for landscape leisure and greening.

1. Prepare the artificial turf for landscape leisure and greening. If the place to be paved is very smooth and flat, such as indoors. Please ignore this process and skip to the second step of lawn spreading.　　　　 A. Put a symbol on the place to be discovered (the artificial turf paving site).　　　　 B, dig a trench 100 mm deep to allow rainwater to flow out.　　　　 C. Spread 75 mm gravel and 5 mm lime or sand on the artificial turf.　　　　 D. Prepare the lawn foundation: level the ground, sprinkle some water, and compact the foundation with a rammer. Make sure there are no stones outstanding on the surface. In addition, the grass foundation must be 20 mm lower than the horizontal ground. 2. Landscape leisure and green artificial lawn spreading. Artificial lawns are packaged and transported in rolls. After being transported to the paving site, the lawn rolls need to be opened and flattened. After placing it for 1-2 days, let the lawn expand to the factory width and naturally stand upright.　　The unexpanded width causes the problem of weak or protruding joints in the later stage of the lawn, which affects the service life and beauty of the lawn.　　 When paving the lawn, make sure that the direction of each roll of grass is the same. To ensure the commonality of the direction of the grass.　　3. Artificial lawn cutting　　 Use a sharp knife to cut off the remaining lawn. In order to make the lawn paving smooth, make sure that the edge of the lawn cut is straight when cutting the lawn. The details that need to be paid attention to are not to hurt the grass. The cutting line should be separated by about 0.5cm from the grass.　　4, bonding 　　 roll up the edge of the lawn to both ends, and ensure that the surface of the joint cloth is clean. Put the seam cloth straight in, add glue to the seam cloth, put the lawn at both ends on the seam cloth, and make sure that the seam edge of the lawn is on the center line of the seam cloth. Use your fingers to straighten the two ends of the seam and pull it out.　　Indoor lawns can adopt the method of point sticking, that is, the glue is modified in the center and surrounding points. Sticky outdoor lawn demand line. Glue is applied to the line between the ground and the seam cloth, and the bottom of the lawn edge at both ends is modified and glued to the seam cloth.　　 When splicing and brushing the artificial turf, you only need to fix the four corners or the edge of the lawn. The center does not need to change the glue. If you don't need to remove it, you can also apply all the glue.